Temple Audio Design DI module

Temple Audio Design DI Module for your Templeboard is a passive direct input box that retains the highest fidelity of your tone.

All Temple MODs install easily with just two screws. This module has a lift and a pad switch. Activate the lift switch if you are experiencing hum from a ground loop. If no ground loop noise is present, then leave disengaged to keep your signal grounded. Activating the -15db pad will reduce the volume of the input signal and prevent distortion from loud inputs.

The module can be used at the end or at the beginning of your signal. Option 1: at the end of your signal (wet out). Use your DI MOD at the end of your signal chain so that your effects are sent to your outputs. Send the balanced XLR out to your mixer or interface and the THRU to your amplifier. Option 2: at the beginning of your signal (dry out). Use your DI MOD as an input at the beginning of your chain. This allows you to send a dry signal to the interface / FOH as well as a thru to your pedalboard and amp / interface.